Fogstop Anti Fog Visor Insert for Dualsport Helmets - Clear Large

Raleri Fogstop Clear Large is an innovative helmet antifog insert made in Italy. It does not require any pins for mounting & can be used during day as well as night without any optical distortion.

Raleri Anti-fog insert can used safely on almost all helmet visors with or without pinlock pins. Raleri Fogstop Clear insert sticks using a special adhesive sealant which ensures that no dust enters between the insert and the visor.

Benefits of Raleri Fogstop Clear

• Clear & transparent
• Larger size for Dualsport helmets or helmets without pinlock pins
• Stick-on type - Sticks on visor inner using high quality glue, uses a patented glue sealing system
• Can be used during day as well as night
• 100% optically correct film with no visual distortion
• Replaces Pinlock 120 { Compatible with Pinlock 120 visor, last longer than Pinlock
• Antifog only
• 100% Made in Italy - High quality distortion free insert
• Does not damage the visor by preventing any dust or dirt going in between the visor and the insert
• Tested for antifogging properties as per European standards  EN 166 7.2.3

Fits on:

Raleri Fogstop Clear Large inserts will fit on almost all Dualsport helmets or Helmet visors without pinlock pins. Below are the list of helmets that we have installed the Raleri insert:
• Bell - MX9
• Scorpion - EXO series
• HJC - DS X1
• Arai Tour X5
• Shoei Neotec

Installation: 

Raleri Fogstop Installation Procedure:

• Download the template from link, print it at 100% scale and cut according to the size - https://www.raleri.com/shop/Templates/dimaStandard.pdf
• Tape the paper template on outside of visor using cello-tape. Align the template so that it is in the center ( verticaly and horizontally) to the visor.
• Carefully remove the visor from helmet and neatly clean the inside of the helmet
• Remove the white tape on one side of the Raleri insert.
• Widen the visor slightly (to make it flatter) and gently stick the insert from one side of the visor. Let the visor come back to its original shape. Do not press the insert.
• Check if the insert is properly aligned vertically and horizontally. If not you can remove and start again.
• Once successfully installed, run your finger all along the adhesive to ensure there are no air bubbles and the insert is sealed from all sides.
• Remove the protective plastic cover and install the visor on the helmet.

*To be installed once only, if removed cannot be re-applied.*
*Not compatible with all Arai helmets*

Disclaimer:

• Raleri anti fog lenses do NOT qualify for any exchange, returns, or replacements.
• Images shown for illustration purpose only.
  
• Actual product may vary in finish, specifications, look without any discretion from manufacturer.